Tel: +86-532-88566601
E-mail: sales@successrigging.com

Contact

Qingdao Success Machinery Co.,Ltd

ADD: Guozhuang Industrial Park, Tongji Subdistrict, Jimo Qingdao

 

TEL: +86-532-88566601

FAX: +86-532-85059139

 

E-MAIL: sales@successrigging.com

WEBSITE: www.successrigging.com

Shackle Complete The Artificial Production Process Is Difficult To Operate

The wear and tear of the Shackle in use is inevitable, since it is inevitable, then we will minimize the wear and tear of the Shackle. In the process of using the elevator Shackle, please try to keep the conveyor Shackle in the large gear and the flywheel between the vertical. Shackle ball bearings used as a Shackle wheel, the guide wheel are selected 16Mn material after deep processing. Our company's production of hanging Shackle life of more than 5 years to ensure the normal use of the user.

    The hoist Shackle has a good space, a wide range of applications, can continue to work non-stop through the high temperature drying Road, harmful gas area, spray paint room, before the treatment of paint, freezer, air storage, etc., to complete the artificial difficult to operate the production Process, thereby improving the working conditions of workers, improve product yield and quality. Shackle in the workshop of the material on the air distribution, the design of a reasonable program, the warehouse, assembly line and other related nodes organic combination, to the maximum extent possible to rationalize the logistics of the workshop, resulting in greater efficiency.

1, sprocket mounted on the shaft should be no skew and swing. In the same drive assembly, the end of the two sprockets should be in the same plane, the sprocket center distance of 0.5 meters below the allowable deviation of 1 mm; sprocket center distance of 0.5 meters or more, allowing a deviation of 2 mm. But not allowed to have a friction sprocket teeth side of the phenomenon, if the two rounds are too large prone to off-line and accelerated wear. When checking sprockets, care must be taken to check and adjust the offset.

2, the Shackle of tightness should be appropriate, too tight to increase power consumption, easy to wear bearings; too loose Shackle easy to beat and off the Shackle. The degree of elasticity of the Shackle is: from the middle of the Shackle lift or press, the two sprocket center distance of about 2-3cm.

3, the new Shackle is too long or elongated after use, it is difficult to adjust, see the situation to remove the link, but must be even. The Shackle should pass through the back of the Shackle, the locking tab is inserted outside, and the opening of the locking tab should be in the opposite direction of rotation.

4, sprocket wear serious, should also replace the new sprocket and the new Shackle to ensure good engagement. You can not simply replace a new Shackle or a new sprocket. Otherwise it will cause poor engagement to accelerate the wear of new Shackles or new sprockets. Sprocket tooth surface wear to a certain extent should be used in time to turn (referring to the use of the sprocket). To extend the use of time.

5, the old Shackle can not be mixed with some of the new Shackle, or easy to produce shock in the transmission, pull off the Shackle.

6, the Shackle should be timely in the work of filling lubricants. The lubricating oil must enter the clearance between the roller and the inner sleeve to improve the working conditions and reduce wear.

7, the machine long-term storage, the Shackle should be removed with kerosene or diesel cleaning, and then coated with oil or butter stored in a dry place to prevent corrosion.